As a precaution, save Backup & Disaster Recovery appliance configuration locally to your administration machine (Settings › Configuration › Save Configuration).
Please read the following instructions to become familiar with the steps before moving the appliance:
Change the IP address in Settings › Networking › Network Adapters.
If necessary, change the routes in Settings › Networking › Routes.
If necessary, change the DNS settings in Settings › Networking › DNS.
If necessary, change the Active Directory settings in Settings › Networking › Active Directory.
Also check Settings › Monitoring › SNMP to make sure it will work at remote site.
Shutdown the appliance in Settings › Reboot/Shutdown.
Although not absolutely necessary, if the appliance might be subject to rough handling during the move – consider ejecting the drives (ground yourself first to avoid static), number the drives and ship/transport them separately from the chassis.
The drives must be put back in the proper order. See Settings › Tools › RAID Configuration for proper numbering.
Once at the remote site, boot up the appliance. If the necessary settings were changed earlier, you will be able to access the appliance Management Console about 5-10 minutes after start.
If necessary, a monitor and keyboard can be connected to the appliance.
Changes can then be made to networking (and other settings) via “Quick Start” after the appliance is fully booted up.
Once on site when you can access the appliance Management Console, change the IP Address in Replication › Mode/Options on both the primary and secondary to match again, but do not click Clear. This will make it forget that it was ever talking to another appliance for replication and then seeding was all for naught.